I've been sketching up a custom loop in Blender, as I see the options are:
1. CPU block/pump combo
- Barrow CPU pump block can fit only in 3-slot mode (it's 53mm tall without pump) and would require very low-profile fittings like Barrow 90-degree MF non-rotary.
- Aquanaut can fit in both 3- and 4-slot modes. In 4-slot mode the fittings should be 28mm tall or shorter (TG panel might affect this).
- Apogee Drive II can fit only in 3-slot mode.
- Eisbaer LT solo - only if coupled with a non-restrictive rad.
2. DDC pump with 62x62mm G1/4 top with a fill/drain port (example) can fit between SFX PSU and the radiator. Might be easier to fill and bleed if you add an extra fill port at the top of the loop and attach an external reservoir to it, or add QDC.
3. DDC pump with a 62x62mm <80mm tall reservoir top (example), ideally 50mm diameter cylindrical res for easier cable management. It should be possible to fill the loop through the reservoir while running the pump at a low speed but would be easier through an extra fill port somewhere at the top of the loop.
4. EK-SPC or Syscooling P60/P67 should definitely fit and you can get more creative where to put it but I didn't research this option much.
