REVIEWED: GeForce RTX 5060 Ti with ZOTAC GAMING RTX 5060 TI Twin Edge OC

Reply to thread

Message

So, in order to accomodate a wider graphics card, I have two possible ideas:
Two 3D-printed corner pieces which would be about 1~2 (?) cm wider than the default, and would still allow to mount the same side panel, OR:
Take the rear corner piece, file down the part that blocks the card, and then mount the side panel using some stand-offs.
Does either of those ideas make sense? Sorry for the noise but I just don't want to give up this excellent case over half a PCIe slot.

[QUOTE="Venemo, post: 228319, member: 6926"] So, in order to accomodate a wider graphics card, I have two possible ideas: [LIST] [*]Two 3D-printed corner pieces which would be about 1~2 (?) cm wider than the default, and would still allow to mount the same side panel, OR: [*]Take the rear corner piece, file down the part that blocks the card, and then mount the side panel using some stand-offs. [/LIST] Does either of those ideas make sense? Sorry for the noise but I just don't want to give up this excellent case over half a PCIe slot. [/QUOTE]

Verification