Normal
Does anyone here have Dan A4 V4.1 they could peak inside? I'm still working with rear M.2 MB heat. I had an idea I was wondering if anyone could confirm: I know that the pci riser ribbon is broken up into three strands on V4.1, so... I'm wondering if I could route one or more of those strands between the M.2 drive and the MB so that the M.2 with a thermal pad could make contact with the backplate?I also noticed that the riser cable bends under the backplate much lower than in previous generations of the Dan A4 so I'm wondering if it's still no problem to put a NF9-14 down there? Looks too tight to me.
Does anyone here have Dan A4 V4.1 they could peak inside? I'm still working with rear M.2 MB heat. I had an idea I was wondering if anyone could confirm: I know that the pci riser ribbon is broken up into three strands on V4.1, so... I'm wondering if I could route one or more of those strands between the M.2 drive and the MB so that the M.2 with a thermal pad could make contact with the backplate?
I also noticed that the riser cable bends under the backplate much lower than in previous generations of the Dan A4 so I'm wondering if it's still no problem to put a NF9-14 down there? Looks too tight to me.
