To create the path of the tubes, I started from the block CPU
and backward I came to the rad where I screwed the last curve.
[MEDIA=imgur]qLVwQW3[/MEDIA]
Once fixed the block CPU I cut a rectangle of plexi that I used as a base for fixing the rad,
I have unscrewed 2 of the 4 screws that assemble the outer covers of the radiator and used them to fix the plexi,
I then drilled the plexi in correspondence of the existing cracks on the bottom of the case
and I used the standoffs as feet to reach the desired fixing height
[MEDIA=imgur]yT47n6V[/MEDIA]
[MEDIA=imgur]nsq7Qna[/MEDIA]
the D10S AIO is then fixed with four screws on the cpu (of course)
and with 3 screws under the case that block the standoffs,
I finally added two small upper curves,
using the already existing holes (for the reggi psu) to fix the fan also in the upper part
[MEDIA=imgur]R5Tk2GF[/MEDIA]
