Normal
Time for a little update while I am still looking for a motherboard.Ideally to minimize cost I would like to go with one that goes with my Ivy Bridge and DDR3. But these are hard to find and with the bad experience I just had I am more and more thinking of buying new hardware...My PSU bracket was too weak and the 3d print broke while the support material was removed:So I had to redesign it in 4mm instead of 2mm, but with that thickness I faced some issues and was not able to make one bracket compatible for both regular (vertical PSU) and mini (horizontal PSU) versions.That's why I came up with these two sets L-R and Up - Down:They are on their way, should get them soon!And finally here comes the Makerbeam frame for the mini version, it's getting real![MEDIA=imgur]a/ldeWFO4[/MEDIA]
Time for a little update while I am still looking for a motherboard.
Ideally to minimize cost I would like to go with one that goes with my Ivy Bridge and DDR3. But these are hard to find and with the bad experience I just had I am more and more thinking of buying new hardware...
My PSU bracket was too weak and the 3d print broke while the support material was removed:
So I had to redesign it in 4mm instead of 2mm, but with that thickness I faced some issues and was not able to make one bracket compatible for both regular (vertical PSU) and mini (horizontal PSU) versions.
That's why I came up with these two sets L-R and Up - Down:
They are on their way, should get them soon!
And finally here comes the Makerbeam frame for the mini version, it's getting real!
[MEDIA=imgur]a/ldeWFO4[/MEDIA]
