Normal
Ok, so I tapped the holes for M3 screws, and used 6mm long ones to screw the panels together. And this is how it looks.Notice that the left panel doesn't sit flush, because that side had support on it and the surface finish isn't good at all.I tried very hard to break the corner with my fingers, and couldn't! It's stronger than it looks.What should I do now? Should I break it with pliers?
Ok, so I tapped the holes for M3 screws, and used 6mm long ones to screw the panels together. And this is how it looks.
Notice that the left panel doesn't sit flush, because that side had support on it and the surface finish isn't good at all.
I tried very hard to break the corner with my fingers, and couldn't! It's stronger than it looks.
What should I do now? Should I break it with pliers?
