Normal
Pressed in more standoffs and installed Tappex threaded inserts to the extrusions. Can now assemble it properly.Need to do an extra cut on the rear IO. This part needed extra material as the cut out is so close to the bend. I have to cut out the extra material after bending.Just need to press in the M4 standoffs that hold the front/side cover on. Also take a little bit off the end of a couple of the extrusions. Then can go out for powder coating.
Pressed in more standoffs and installed Tappex threaded inserts to the extrusions. Can now assemble it properly.
Need to do an extra cut on the rear IO. This part needed extra material as the cut out is so close to the bend. I have to cut out the extra material after bending.
Just need to press in the M4 standoffs that hold the front/side cover on. Also take a little bit off the end of a couple of the extrusions. Then can go out for powder coating.
