Recent content by viper_11

Hi there, Finally, I went down into the SFF rabbit hole and I decided to build my own 3D printed case. Redesign after redesign, and shrink after shrink, it can't be shrinked anymore (yet) Disclaimer: -The case it's a prototype just for testing. Need some adjustments. -It's not a project for...

Thank you for your answer. I will consider. Maybe it's a bit on the line for my use.

The MB, I'm between 2 or 3 models. All with 12-24 range. (BCM MX610HD, The GPU it's a RTX 5060 Ti with 90-100w peak (undervolt). It's pcie 8x. The CPU 12400F with maybe sustaines 20-40w (gaming). But my doubt is. If I use the standard PSU ATX connector for GPU and 4pin EPS, BUT, I took 12V line...

Hi there, I'm working by fun on the smallest mini-itx pc possible with mid-range gpu. The thing is: I have an HDPlex 250w GaN, and I want to feed a thin Mini-ITX board with DC-IN and EPS 4 pin for cpu. As concept: Will work if I short the PS_ON for power on the PSU and take the 12V line from...

Hi Gilido, I don't want to use the original mac mini psu. After thinking what I want, I think It would be a mess because the PS_ON Signal. I think It's impossible to manage two computers with the same psu if I want to power on and off independently

Hi everyone, I’m looking for advice from someone who understands electronics. For a while now, I’ve had a PC and the guts of an M1 Mac Mini inside a Ghost S1 case and I was quite happy, but now I want to go further and I’m building a 3D printed case as compact as possible. This PC will be...

Hi Everyone, I fell down the small computer rabbit hole and now I can’t get out :)