Recent content by VELKASE Michael

Here are the first RTX 4000 series graphics cards compatible with the Velka 5/7 rev 2: Nvidia GeForce RTX 4070 FE MSI VENTUS 2X GeForce RTX 4070 12 GB PNY GeForce RTX™ 4070 12GB VERTO Dual Fan ZOTAC GAMING GeForce RTX 4070 Twin Edge GAINWARD GeForce RTX 4070 Ghost OC PALIT GeForce RTX 4070 Dual...

Yes, available until further notice

Yes, here. Just enter “test22” to view the product page to order without quotation marks. https://www.velkase.com/test-products/slim-console-early-version

CPU cooler clearance should stay in the 50 mm ballpark, 4080/4090 FE might fit but can’t confirm yet as the design is not finalized. I can still use feedback, if not for this exact case then for a revision of it should it come to that.

Unfortunately, I cannot as much as I’d like to be able to. Everything is in flux.

Only the shown model is currently available so the 3090FE will not fit, sorry

Quickly about the feet: just rotate the stainless steel bracket 90 degrees if the holes don’t seem to line up. The grid spacing is different horizontally and vertically due to the honeycomb pattern.

Unfortunately I do not spares to offer but they can be purchased separately on other sites. They just need to be 1 inch long and have a 6-32 thread on both the male and female ends. I would suggest checking Digikey and Mouser for replacements.

It’s actually not finalized yet so I will have to share that later, otherwise there will be several sets of conflicting specifications. 320 mm long GPU and 7.9 L volume mentioned previously are some of the goals.

The Velka 3 changes are very conservative this time around. The focus is on keeping the same features with a better execution: -same size (3.9 L) -same hardware compatibility +/- a few mm in graphics card dimensions and fixing some rare incompatibilities, inconsistencies -surface finishing...

Nothing is decided regarding the riserless case yet

I will have to share the answer to that soon, closer to launch.

It does not have this feature currently but I am thinking about it. There are a lot of considerations to make when it comes to fan mounting in general: 40 mm, 60 mm, 120 mm, 140 mm. Implementing it would require one of the following: 1) Custom die for punching vent holes in the side panel for...

I have seen it but they don’t have much in common. They have similar hardware layouts but different compatibility, vents are in similar positions as a result, both are designed for vertical and horizontal orientations, but that is about it.

Hi, feedback is always welcome. It's useful for other cases too. The design of this one has changed significantly and is looking to be 7.9 L with triple slot 320 mm card support, different I/O, and other more refined features. A new sample should be ready in about 2 months and then the first...