Recent content by triptronix

Looks like the sync cable connector is too long and it is conflicting with my custom case. I cannot connect the sync cable to the mini 160 sync pins. I was thinking since the connectors on the dynamo 360 and mini 160 are both fan header pins can I just custom make a sync cable using two pin fan...

Thanks. I'm assuming that I can extend the sync cable if needed using the same wire coloring and gauge without compromising it's capabilities (syncing) ?

Hi, I'm having the issue where the CPU fan is still turning after powering down. this is forcing me to pull the power brick. It was happening since the beginning and really did not mind it until now. I was reading that I need to use the 2 pin sync cable to correct this, something about the power...

Final Update: I found the problem after going through every component installed and using the Q LEDs/POST beeps, I determined that the issue was the PCIE riser I was using is faulty. I switched it out with a working one and we are now off to the races. The dynamo 160 + 360 is fantastic!

Update: I contacted ASUS support with problem and they are stating that the issue could not only be related to memory, the cpu or faulty MB. it could also be a PSU issue (voltage spike/over voltage). I'm planing on taking everything out of my mini itx case, going bare bone and switching down to...

I think it may be related to the MB not being compatible with my CPU and Memory even though is listed on the ASUS QVL document. Supposedly the amber light is a memory issue and the red light is an CPU issue which could mean component failure I cant find any additional help on this. I may just...

Hi, I'm having a weird issue withe Dynamo 160 mini + Dynamo 360, I have both devices setup as per the picture above and the jumper is set closet to the DC in header on the 360. The 360 is lit up with a blue light when powered on, the GPU fan turns on, the case fans turn on, the CPU fan is...

Is there a setup guide just for Dynamo 160 mini? Thanks

I am wondering if I wanted to use 2 Dell 330w bricks how would I setup that up? Is there anything extra that I would need to sync or run the bricks parallel to each other?

Great! Thank you again

Sorry last question. Does the combo kit come with two sets of cables one for each device? Thanks again

Thank you for the quick clarification =)

Hi I'm new to SFF power supplies. I recently purchased the Dynamo 360 + Mini160 kit and was wondering if I can run a single dell 330W (7.4mmx5.0mm) brick adaptor straight from the Dynamo 360 while the Minii 160 is connected to it? What type of wattage output can i expect from this setup...

Hi Matt3D, I placed an order for the XCaseS yesterday and I am trying to find out how I can get the HDPLEX 400W DC ATX into the case and combining it with a Dell 330W external brick. Looking at the layouts there appears to be room, 30+ mm on the left of the MB and maybe 50mm on right of the GPU...