Recent content by Tazpr

I actually think the TX240 is not a great deal behind most other 25-30mm radiators if it has decent fans due to the fin density, so I reckon a TX240 + 2 Noctua A12x25's would be extremely capable.

I'm in, I'm sure others will too - you're onto a winner Lyt! The radiator compartment is still 45mm yeah? Being able to run an XSPC TX240 with 2 25mm noctua fans is going to be a strong configuration when compared to comparable cases

Looks great - quite possibly a perfect use of space

I think exceeding 9L is putting it too close to T1 - sub-9L is part of this cases identity. Personally voted option 2: 2.5 slot support with reduced CPU cooler height.

I'm interested in seeing it with a 235mm GPU pointing out the back and what space is left.

Duuuuuuuuuude it looks so fucking good all together and painted! Great work! How long til that one gets shipped out to you for trial fitting?

Although interestingly Optimum Tech's latest video showed a 10900k (overclocked) and an RTX 3090 (undervolted) running at very reasonable temperatures under a single 240mm radiator so GPU size shouldn't be a major concern if you expect people to be watercooling it like I am. I think an important...

Would these tweaks require a new case or would it be something that could be achieved through a replacement front panel or "Enhanced GPU Support Kit" or something? Edit, may be a better question for the T1 thread sorry - can ask there if you'd prefer?

So I'm doing some brainstorming - RTX 3070 FE has a very short PCB, looks about ITX length - so I'm planning a loop using one of these with one of EK's FLT 120 res's as it's 58mm thick including mounting elements and then run the case in 2 slot mode with a standard waterblock and rad and...

@Wahaha360 did you end up getting your hands on your Strix card?

6800XT will fit in 3 slot mode, 6800 will fit in dual slot mode ?

Very sleek and unique design - well done. I like that you used a 3080ti model in the renders haha was wondering what the end mounted 12 pin was ?

You can't saw the end of the heatsink off though as it will completely nullify the heatpipe effectiveness and result in the card overheating. There may be ITX cards coming, but by no means should you saw off the end of the reference cooler.

What about... The LT solo? Your options are limited but I think there will eventually be W360's own solution that's listed on the FormD website.

Yeah that's true - part of me was wondering if there'd be a use case for mounting the Flex ATX PSU on its side under the motherboard to limit GPU length but grant greater CPU cooler clearance and potentially some slim 120mm case fans. Like a shorter and fatter Velka 5 haha