Recent content by supremeMilo

Do you only use a clip on one side (IO not ram) of the 120MM fan?

For those that have the blackridge with 120mm fan, do you use the fan bracket to hold it on or just pry it with the vlp and the riser? I can't figure out how to get the clips to work with the riser installed.

I only have the 600 gold, but am switching to the 750 plat psu, as I think that while working, 600W psu is the loudest thing in the system.

Isn’t the FE exhausting hot air out of its PSU side fan?

Going for the Kingston, have a 3700X, Asrock B450 and 3080FE, switching to the Blackridge to put an exhaust where my 645LT currently sits.

Thanks, ordered, wondering if I am going to notice going from 32GB to 16GB..... needed ram for my NAS/Server anyway and the VLP wasn't THAT much more than a normal 16GB kit.

Which 120mm fan is recommended for the black ridge?

https://www.3dmark.com/spy/14300112 Here is my Timespy result with - Corsair SFX 600 Gold , 3700X, 645LT, Losercard PSU bracket, psu normal orientation shortened cables, intake fan under mobo, and plastic removed and undervolted 3080FE. Sound wasn't terrible. Note this was done on a bloated...

Not yet, running time spy the pc wasn’t as insanely loud as heaven tho.

Both sides were on, I'm not sure I would recommend this but it definitely works.

Will need to try again at 4K but never hit 85C with 3080FE.

If I take out the plastic sheet can I put it back?

Is there any extra noise/turbulence with the XC3 being as close to the side panel as it is in the Dan A4?

It's not there for me right now.

Is this thread not showing up here https://smallformfactor.net/forum/category/dan/ ?