Recent content by Speedster

  1. Speedster

    Production FORMD T1 (READ FIRST POST)

  2. Speedster

    Production FORMD T1 (READ FIRST POST)

    @Wahaha360 answered you the last time only two pages ago: https://smallformfactor.net/forum/threads/formd-t1-classic-read-first-post.9933/post-245304
  3. Speedster

    Production FORMD T1 (READ FIRST POST)

    Sorry, my ESP is off so I don't know what motherboard you have. Most should have a BIOS option for throwing an error on CPU fan speed/not running. Worst case scenario split the speed wire from the fan to the header so it reports a RPM value.
  4. Speedster

    Production FORMD T1 (READ FIRST POST)

    Managed to nab another T1 second-hand off forums here in Australia and put the first system back on air for Red vs Blue: T1 edition 😁
  5. Speedster

    Production FORMD T1 (READ FIRST POST)

    You're pretty much limited to a pump/block combo like the Apogee Drive II or Aquanut. The Barrow combo may also fit with suitable fittings.
  6. Speedster

    Production FORMD T1 (READ FIRST POST)

    The GPU is behind the motherboard in the T1. The riser cable might get in the way but it's not a big wall like a GPU would be.
  7. Speedster

    Production FORMD T1 (READ FIRST POST)

    I use the Classic SE 240 with two A12x15 chromax fans.
  8. Speedster

    Production FORMD T1 (READ FIRST POST)

    Right angle fittings would be more than 25mm though? (unless you go for the Koolance swivel fittings) Seems like 2-slot config only to use standard rotary fittings with that monoblock.
  9. Speedster

    Production FORMD T1 (READ FIRST POST)

    I don't even have an AIO in mine - Black Ridge with 92mm Noctua on the CPU, and a Gigabyte 2080 Super on air. Two Noctua 25mm fans exhausting air from the case. Works really well and not too bad on thermals or noise when the load ramps up. My interest still holds.
  10. Speedster

    Production FORMD T1 (READ FIRST POST)

    Add some pslate cables and watch your wallet disintegrate when converted to AUD!
  11. Speedster

    Production FORMD T1 (READ FIRST POST)

    Nice build! You know the RGB cover pops off so you can spin it 180º to have it the right way up? :)
  12. Speedster

    Production FORMD T1 (READ FIRST POST)

    Delivered today, and built up. I had to use both the imgur and flickr albums to put it together successfully.
  13. Speedster

    Production FORMD T1 (READ FIRST POST)

    Heatpipes facing down. The wicking action of the heatpipe is less effective as it has to fight gravity. https://noctua.at/en/productfaqs/productfaq/view/id/26/
  14. Speedster

    Production FORMD T1 (READ FIRST POST)

    Yep, I just had an order from Bitspower arrive (magic cube and a temperature stop fitting). 7 days, FedEx from Taiwan to Australia. Better than EMS!
  15. Speedster

    Production FORMD T1 (READ FIRST POST)

    It depends on what clocks you set as well. My 2080S is undervolted to 900mV @ 1860MHz
See more
Top Bottom