Recent content by sandyware

Maybe… Bilibili — cn ver. of YouTube — is accessible? You can try take a look at my original video. https://www.bilibili.com/video/BV1VB7B6kE43

The screw is connected to a standoff, allowing it to reach the microswitch. By cutting out a small strip, it can be pressed down.

Today I want to share a rather niche and fairly ridiculous DIY mini PC build. The purpose of this design is to push the volume of a SFF PC with a discrete GPU below 1 liter, and to keep pushing it even further. Can you imagine that it is close to the size of a smartphone? The main character...

Check throttle reason in HWINFO64.Also the VRM temperature of the board is very bad, it provides about 80w continous power. Try limit PL1/2 to 80w.

In the new BIOS of the DeskMini X600, the "Performance Mode" option has been removed, resulting in extremely low power limits. This issue can be resolved by disabling Prochot VRM Throttling and Peak Current Control under Advanced \ AMD Overclocking \ Manual CPU Overclocking. However, please note...

The RTX 50 series requires a PCIe 5.0 riser connected to the front-facing M.2_1 slot. Both the 5060 and 5070 are compatible. PCIe 4.0 riser connected to M2_2 slot causing screen flash black.

Bios 4.10 has caused a significant performance drop.

Bro, the download link has expired. Could you please reupload it? Thanks a lot!

Use bios 1.43(for ryzen 7xxx and 8xxx) or 4.03 (for 9xxx) ，and make sure you turn on "performance mode" in bios "OC tweak" page. Bios after 4.03 remove this option.

3.3V is provided by the M.2 slot on the motherboard and directly connected by the riser cable. Riser only requires an external 12V connection, connect it to the PSU.

Does the USB port still have 5V output after automatic shutdown?

3x12V pin ,and 5x GND pin, each soldered to the same wire

You can find it in the manual of RT9553 protection chip.

I have no idea, the difference between the two board is very significant.

Stack solder a 100K resistor on top of the existing component at the indicated position to reduce the under-voltage threshold, making it compatible with a voltage range of 12-19V. No need to remove the component. This will lower the fan power supply to 11V, slightly reducing the fan speed at...