Recent content by roscoejp

Can you flip it vertically so you don't have a hair braid of cables running from the top/rear of the case toward the table?

@Josh | NFC The GPU Spreadsheet doesn't indicate what the green highlighted lines are. Blue is (confirmed?) brickless, purple possible brickless w/ mods, and red is known possible with brickless? Is green confirmed brickless w/o mods?

I think I missed that message in this thread. None of the charts on the first post seem to put a 120 near the 240s.

@Wahaha360 The Barrowch website lists that radiator as being 30mm thick - I thought 25mm was the max height for the rad in this case?

Try this: https://www.silverstonetek.com/product.php?pid=597&area=en Although I would like to see a model that was 2mm taller to be able to fit the more common 27mm aio rads that a lot of manufacturers are using.

My vote would be for the USB A+C with the single 19-pin USB3.0 header. Hard to find any ITX AMD boards with the new front panel connector and it severely limits mobo compatibility if you want to actually utilize all of the front panel ports. Right now the USB C port is just taking up space (on...

@Nouvolo is there anything that would prevent mounting the stacker on the bottom and putting an AIO in there? If possible I'd want to have ventilated panel on GPU side and TG on the Mobo side. With the AIO pulling air out of the case should get some good airflow over the GPU.

@E0000B6FAF25838 That was indeed the bad idea I was thinking of. I didn't realize that the 645 was already available over here so I might actually swing one of those and see if I can improve on the bad BS2 thermals I have. Back home the 645 still wasn't available so I was thinking of getting a...

Dumb question - would using a 92mm fan on a 120mm radiator be doable? 120mm radiators are a lot more common than 92mm. @KSliger Can I get a diagram with the dimensions of the front spinal cutout on the SM550? I'm wondering if a slim 120 like the TD03-Slim would fit with a full size 92mm fan and...

Is the l9a running full bore at that point? I'm trying to figure out if I want to go with the l9a or with an AIO once the next set of AMD chips launch (and hopefully mobos with support for the front usb header)

@KSliger Is it possible to move the cutout in the center spine back or the front fan mount more forward? I'm thinking that you could fit a 120mm radiator with a slim fan in the 560 (and maybe in the 550 thought routing the tubing around the spine would be hard unless it had swivel hose mounts)...

The riser cable does block almost ALL of the vents directly above the CPU even when it's bent tightly... @KSliger do you have any right angle riser cables that you think may work with the 500? I think getting some of the vent uncovered above the CPU may help with the passive setups (although I...

Did I miss the part about ordering the hard-drive mounting caddy thing? It looks like you can mount 2 SSD stacked in the case but I didn't get any additional hardware to actually be able to do this.

Would the l9x65 be a good fit for the case without the fan? It's pretty much a solid wall of heatsink with no air-gap and it still keeps within the keepout zones. https://noctua.at/en/products/cpu-cooler-retail/nh-l9x65 Also it's 340g with 51mm height with no fan per the spec page: Height...