Recent content by RaihaX

Just use 3D Hub or treatstock? I assume is available in CA if its available in AUS!

Saw a 3950 build recently and he was happy with the temp/performance but it is with the 645.

I just printed them figure is easier then taking out the dan a4 box from storage lol. will put them on when I plan to redo my system a little bit (new cables, noctua fan gpu mod) And test it to see if it makes a difference at all.

There are a few that raise them between 5-15mm I suppose it doesn’t really matter right? Just curious on how much of a difference it makes; if it even makes any. Ps. I’m referring to feet spacers.

Wondering if anyone know if raising the case with those 3d printed spacers actually help with thermal? My 3D printer is arriving soon and I am just finding things to print...

interesting mine went through just fine (made a u shape so it bends back in), if I have a chance I’ll take a photo.

You should route a bit of the power cable towards the riser cable that way the bend is not so tight, just my 2c.

I third this - my old case I couldn't put one of the motherboard stand off as it blocked the GPU connector (Geeek A50), if I had a low profile right angle it would have been a different story!

Pretty cool - subscribed.

Ah fair enough; yeah would have been cheaper through there but they literally posted a few hours after I bought. I suppose my consolation is that I got it real quick! ps. my Birthday is at the end of March too lol.

If its from OCUK it took 3 days to get to AUS so you would be fine :D

Yeah I ended up using a manual curve, will keep an eye on temp to see how I go, realise the bulk of the noise was mostly my chassis fan anyway so i crank that way down 27% until temp gets real high (figure this will be just as good if you had no fans!) Still got to swap my fans on the Zotac...

Yeah same with mine - i even put mine on the "silent" mode (B450 Aorus) and is never that low so I was just wondering if I need to reseat my cooler, but i rather not unless I know for sure.

Can anyone confirm if the l9a running around 1600-1800 rpm on idle is normal? My temp seems normal when comparing to other Dan A4 users so I assume that speed is normal but then I saw the above poster where his fan is at 750rpm on idle on his l9i, so now I am not sure.

There should be arrows on your fan to show you which direction the air will be going - can't go wrong!