Recent content by nsiderTalon

For now I'm not cutting down the Heatkiller Tube 100 res, so it will need to hang over the first PCI-E slot. It works out for me because I have two half-length PCI-E cards that will populate those top slots

Well, that was a bit lucky, haha. (HWLabs 30mm thick rad, Noctua 25mm thick fans, EVGA 1080 Ti SC2 with Hydro Copper block)

I should have more pictures with all major pieces in place early next week, most remaining parts are arriving over the weekend. Let me know if there's any particular angles that would be useful for planning your loop

Were you running a FTW3 or a SC2? My bracket for the SC2 waterblock just arrived and I'll be confirming measurements soon.

Yeah, I'm planning for the fittings to remain in the same orientation as @fabio's, but for the whole res/pump to hang lower. The in/out ports should be hovering over the PCI-E slots at this point, probably below the Intel Optane drive you see in the top slot of my pictures. (And if that...

It might depend. @fabio is using an E-ATX motherboard IIRC. And in my loop I'm not planning for a tube to go between RAM and res. I'm currently using G.Skill Flare X RAM (40mm tall), I'm hoping that Trident Z (44mm tall) will fit as well. (I also may be overly optimistic about the size of this...

I should be able to get away with a third option, @fabio mentioned to me that the Heatkiller Tube Basic Mounting Kit can attach to EK's universal 120mm fan pump bracket. According to my measurements, this should allow the front radiator to remain in the current position, and the res/pump will...

I'm in the process of a upgrading my Cerberus X Threadripper build from an AIO to a closed loop extremely similar to your build. So far I've settled on 2x HWLabs GTS 240 X-FLOW radiators with A12x25 fans on each. I'm happy I went with the X-FLOW version instead of U-FLOW, it should simplify...