Recent content by matique

Excited for how this case will turn out. Keep going at it! Triple 240s would be so nice, especially if it can accommodate bigger gpu blocks.

Also just to confirm, flow is: Inlet > fins > ddc > outlet? So essentially reverse flow vs normal cpu block?

May I know where this is shipping from? Shipping to Singapore is mad expensive so I might send it to a forwarder.

Any consideration to add about 10-12mm in height to accommodate Phanteks T30 fans? They're the absolute best right now and would be nice if it's an option to use them. Otherwise, the extra clearance could also help others use phanteks halos to add rgb to their performance fans if they wish to do so.

Hi, could we have a render with rads installed of the maxed out config with dual 240 + 360? I am very keen on this development & wish for its reality.

yep barrow rotary. Slight bulge, but it's because of the ddc heatsink than the barrow fittings. maybe a 1mm bulge? I can still close panels without issue.

I've removed photo as suggested. Didn't think of it being used as a copy, my apologies. I've already emailed your CS and they replied saying it is within tolerances, but I feel that your tolerance is pretty wide :/ but that's just my opinion, you guys have the final say anyway. That being...

Well i'm excited for the 2.0 then, as more cooling wouldn't hurt. Currently even with one of the better slim 240 rads (magicool g2 + 3 fans) it can't beat an m1 with a hwlabs gts 240 (2x 25mm fans) + tx240 bottom (2x 15mm fans). I will be embarking on fitting a second rad on the T1 soon, so...

What do you mean it needs to cool the M1 & meshlicious? Do you mean cool as well as them or...? Also, apologies if i missed it, but is your cpu pump block thing still going ahead as planned? Because if it is, i hope you manage to partner with a OEM that does fins well (large area, thin & dense...

a. yep 47C is for the front, and it's a gen 4 so it will run slightly hotter. This was benchmark during gaming and my games are on rear m.2 so maybe that's why. It never crosses 65C from what i can tell. b. Currently singapore is experiencing a slight monsoon season so the lowering of temps is...

I've been lurking here for awhile, but have completed my build for awhile. Here's the CPU side: And here's the GPU side: Temps: Specs: AMD 5600x Gigabyte B550i Aorus Pro AX Corsair LPX 3800mhz 15-19-12-36 Corsair MP600 2TB Corsair MP510 2TB Corsair SF750 ASUS Strix 2080ti Noctua A12x15 x2...

Precisely! That's why I am quite annoyed. Surely having deeper cuts in the fins would result in better temps, and here they are saying it wont affect performance. Wow yours is pretty appalling. I hope they find out what's causing these defects and rectify them. If i had seen this before...

Nouvolo replied saying that my plate is within specs and will not be moving forward to an RMA, which is a little disappointing. They said if shouldn't affect performance. I've asked if I could purchase a better plate instead. If that can't be done I'll just bear with this a little longer till I...

Yeah but the outlet port isn't close enough to the fins, and since water follows the path of least resistance, it won't flow through the fins well. I didn't try it as it would be impossible to close the side panel with the supremecy plate as it's almost twice as thick as the aquanaut plate, and...

Probably not, it should have a depth like the supremecy too I think. Someone else correct me if I'm wrong.