Recent content by madejackson

Happy to finally share my Setup with some delay: All in all, I'm very happy with the setup. Only the Noise is a little bit too much. I'm not that impressed with the Noctua NF-A12x15 PWM. The Noctua NF-A9x14 PWM are far more quiet, near silent in fact. Unfortunately, I'm not quiet finished...

Hey Riba, Thanks for sending my cases so fast. I received them last week and already installed one of them. I experienced two issues noteworthy: 1. You won't be able to screw in the riser cable in the optional standoffs for 3-Slot's GPU if you have already installed the ITX-Mobo. You'll have...

I suppose REG means registered, which will not work with any consumer grade board. Only ECC will be supported. So the mentioned kit is definitely not going to work if that is the case.

My kit is exactly what you are looking for: CT16G4XFD8266S

After disappointing results with my adata vlp ram, i ordered Crucial 2x16GB ECC Memory CT16G4XFD8266S. As hoped they are indeed Micron E-Die (dual Rank). Happy to announce very good compatibility with Ryzen 3rd gen. I am running them now [email protected] fully stable (3900x + strix...

Some experience with my VLP-RAM for you all: My purble ADATA 2x8GB VLP Kit from china did not run better on my new R9 3900X than on my R7 1700 (3000C16). In fact, I found them only stable on the 1700. On the 3900X, I haven't found a stable setting on 3000mhz+. On the other hand, my very low...

Very interested in your result. What system (Mobo/cpu) do you use?

I just installed my adata vlp-ram (2666mhz) with my 3900x on a strix b450-i. Best Freq i can get is to 3000mhz (1.36V). everything above throws errors or won't boot at all. I haven't tuned the timings yet.

I got the Gainward GeForce RTX 2080 Ti Phoenix GS I am planning to replace the fans with 3xNF-A9x14 CPU cooler is an alpenföhn black ridge with VLP-ram and a NF-A12x15 (Mobo: ASUS ROG Strix B450-I, SSD: Mushkin Pilot-E 2TB, PSU: Corsair SFX 750W Platinum)

My 3900x arrived yesterday. 2080 ti arrived last week. Now it's just your case missing to finish my new build :D

Awesome :D Count me in for ordering two of your cases as soon as available.

Nevermind, I just made the calculation, an (m)ATX Mobo + FlexATX PSU would be 325.5mm wide. Probably won't fit :(

Sounds good ? looking forward to the final product. btw,I really like the"unfinished" look of the raw metal prototype.

Very fast response. Thanks :) But I think you missunderstood me. I am going to build my first sff pc soon. I really like to have a beefy gpu with +2 slots. Hence why I like your case. I share my office with my gf and for asthetics, I'd like to have the same case for her pc. She has an...

Hi riba, I really like the design of your case and the ATX-Compatibility is a real killer feature. Would it be possible to add compatibility for a 3-Slot-GPU in combo with an ITX Mobo? It would increase the possibilities even further. I'm looking for the same case for my systems. I would need...