Recent content by Mackan

Ok, seems I lost count after all.

Any release date for the M1EVO, the O-ATX or the O-EATX is unknown. And yes, I believe we are talking about 3 cases in total, where M1EVO is the only one being mATX. But from discord, it seems the M1EVO is to be released first. Perhaps late April if they sort out the mesh steel side panel...

When I saw the newest render I was stoked. Clean, symmetric, and finally a good power socket placement -- in the top corner, out of the way. Compare to e.g. Asus AP201, which has the same placement (though rotated 90% which I also prefer). So, I hope it stays there in the corner. As I actually...

Survey was checking interest for shipping in December. But yeah, what are another couple of months, or years. If it is one thing we are good at, it is waiting. Personally, I am curious about the O-ATX.

I was just reading about pcie 7.0 and 4-slot GPU:s coming. 😟 Different standards (like hole placement and physical size) for risers is already bad, but I don't understand the increased wattage race for GPU:s. It feels like Nvidia started this with the 3000-series, to make sure they had the...

I would imagine you get the best out of the Z39 by switching its fan to the Noctua fan, and then use exhaust. Might get a little hotter compared to intake, but intake would probably lead to maximum turbulence noise with the fan being pressed directly against the side panel. At least that was the...

If there was a 300W 12V GaN wall charger that handles high ampere, then our 12V DC-ATX builds are suddenly very attractive. The one mentioned above is 19.5V though, didn't see a 12V on that store when I looked before.

Missed it. :( If it is only going to last hours before being sold out I doubt my chances. When approximately will the next batch be available?

I have seen a nice looking cnc aluminium C14 "extender" on taobao, to move the connector 1-2cm back, to prevent cases of interference. You can even stack 2 of them for better clearence.

I think you have a good "high" location for the C14 inlet in the current P-ATX V3, and I hope it stays there. If positioned in the middle, it would have to be routed over the motherboard in a very visible way. Does not compute in my ocd brain.

I did, the front panel bracket and side panels are still steel. That's why I asked.

Really good changes! Some comments. Maybe consider offering a longer securing piece for the GPU, at the back of the case. I believe the current one will not secure a single slot GPU, or any other single slot pcie card. Is there any reason you are not going for 1.5mm aluminium on everything...

Regarding pcie risers, do you know what 4.0 risers will fit this case? E.g. a direkt Linkup one?

Looking forward to get one. I assume you were otherwise happy with the prototype except the "mistake" with the front panel they made? It seems sturdy enough? And I assume you will offer it powder coated in black?

Yeah, got an email about it. I just did what the email said. :)