Recent content by KetchupFTW

Could anyone explain how to exactly tuck the cables so that I am able to install a 120mm fan (25mm thick) fan at the bottom and have space for an sata SSD? I tried before but the side panels wouldn't close. I'm using a Corsair SF450.

Another question: does this case feature a motherboard cut out? My motherboard has the M.2 slot at the back.

So the weak magnetic side panels are a main complaint I read online. How bad is it really?

Does this case feature a motherboard cutout at the back?

Added 4mm magnet holes to the sides of the case frame, to better hold mesh panels in place. Magnets cannot be included due to air shipping limitations. Couple of questions about this: 1) Does 4mm mean 4mm in height or in diameter? 2) Is installing these magnets as easy as click-and-go? 3)...

XFX Thicc II 5600 XT

Also, would a GPU with these specifications (28 x 14.8 x 4.4 cm) fit into the case when put into a three slot even though the height is apparently too much?

Where did you find the maximum GPU height this case will be able to support? On page 1 of this topic I've only found some information about the length and about the width.

Won't fit in a dual slot configuration I mean of course.

But 40mm isn't either apparently, since it won't fit this case unfortunately enough. What websites are you reffering to?

But not all 2 slots are made equal. Will the bottom two cards for example fit? Board Dimensions1) 240mm*118mm*40mm 2) 28 x 14.8 x 4.4 cm Both two slot cards, but no right?

Graphic cards support: 312mm long, 2 or 3 Slot GPU (39.2 or 59.2mm from Side Panel to GPU PCB, including 1.6mm GPU PCB) So what is the point of a 2-slot card if the vast majority of GPUs are wider than 39.2 mm anyway? Almost only ITX-cards will qualify, and you won't even be able to make use...