Recent content by k1llah3rtz

Hi Folks, anyone got ideas on how to externally mount a 360 rad or a 2nd 280mm in a meshlicious? running a 280mm already with a 3090 air cooled but thinking of switching things up with a hardware mod... thoughts welcome TA

new build … using XSPC long screws to push GPU to the outside of case.. need to get custom cables to reduce internal congestion. phantek 280 glacier one very quiet and fits after some convincing

anyone know which AIO's fit in 4slot mode?

anyone have a completed 3090FE build in a meshilicous? i have both yet to be unboxed, moving the card over all the way to the panel seems the way forward but would be great to see any tips :)

Web store seems to only have the Raw and the EU stores don’t ship to the UK

Anyone got advice on how to get hold of Logue cases in the UK?

Which one is that ?

of course but with such a small loop and whilst a total PITA, draining pre-flight and refilling could be an option. alternatively get an AIO for the GPU and stick to air on the cpu

what about a thorzone mjolnir? has room for 240mm IIRC and with a barrow block/pump/res should be buildable... so remove the stock GPU cooler and make it 30% smaller, low-profile fittings = profit ( i think )

thanks everyone - i'm no further along. The M1 looks like a cool build but after listening to @optimumtech reflect on his M1 build and thermal constraints, i'm now wondering if dual rad is the way to go and go vertical with a single larger rad i.e. 280mm - e.g. meshlicious. also thinking...

from all the reading i did on this, founders editions will fit the easiest but have airflow challenges. I can confirm that the XC3 will 1) fit length wise but critically 2) there is a good deal of clearance at the top. there is about 15mm of good clearance for a 2/2.2 slot card. i have my...

thanks @Shaytanya and @dondan - i'll post a couple of pics once back at my desk, the setup worked just fine with my 2060 Super as it only needs one pcie power, but with both connected it doesn't with the tubing routed around the front. the issue isn't with the cables from @pslate which are...

Hi All, Looking for some friendly advise please :). Currently have a Dan A4 build which i've just about complete barring a bit of 3d printing that needs to be completed but have an AIO unit coming for my GPU and wondered which low-volume ITX cases can hold a 240mm rad (for the GPU) and a 120...

hi - i'm trying to get my 645LT fitted with custom cables from pslate to fit with my SX700-PT and have problems as both PCIE power cables are plugged in and obstruct against the GPU side outlet on the rad. it appears that i've got two options: 1) route one of the tubes around the back of the...

Hi All, I've gone throught the thingiverse and found a load of different templates etc that can be 3d printed but wondered, is there a list of the most recent/most usable? i've been battling to get my AIO fitted with a silverstone SX700-PT without routing one of the tubes behind the PSU and...