Recent content by Johnny0971

I would happily fill the slot for Sweden, been following this thread and case since the very beginning, I have also owned a Ncase M1 and a Ghost S1.

I'm not a reviewer but I have had Gentle Typhoons and can compare them to my new Noctua NF-A12x25, and the Noctuas are way more silent. The GT fans have a very special and annoying hum to the motor that really bothers me, even at low RPM, and quality is less.

Yeah, I can really recommend these fans, so silent and moves a huge amount of air, it is crazy how good they are. I'm very surprised actually, I had the Noctua iPPC before so I did not expect them to keep roughly the same temperature, but they do. The filters I'm using are from...

For those of you who consider getting this case or just like Noctua fans, this post is for you. I did this build in december and I love the Cerberus X case, it is as close to perfection in a case that I have ever got. Rough specs are Threadripper 1950X, a Sapphire RX Vega 64 Nitro+, a 3,5'...

Could you possibly put it next to a Cerberus X, and Cerberus for size reference? Would be appreciated. Thank you!

Hopefully you will be happy, I have owned several high-end cases, Ncase M1, BeQuiet DarkBase 900 Pro, among some, but the capacity, design, and quality of Cerberus X (and non X) is amazing, I'm super satisfied with my case and Sliger are easy to work with and very helpful. To have the...

I use the V2 one with cutouts for the feet : )

Guys does anyone know if it is possible to fit a E-ATX motherboard and a SFX PSU in the front of the Cerberus X at the same time, or am I restricted to using ATX size board due to SFX PSU blocking? Thanks!

I got a Cerberus X, and I'm using Ncase bottom filter for bottom intake, and I'm using 2x normal 120mm filters that they have for front fans, and for the side vent I use Ncase top filter. It fits really good, I can recommend them.

No, it wouldn't have been possible.

It is the Gigabyte X399 Designare EX, missing the middle hole in the top row, there is a heatsink where it should be. I used a dremel to remove the standoff in the case to make sure it did not make contact with the PCB. I would have loved seeing the MB standoffs being screwed in with a...

Do you plan on making the motherboard standoffs removable? I had to dremel away one of my standoffs since the motherboard I used did not have all the holes an ATX board normally has. Just curious, super happy with the case ^^

My opinion is that this one with window and vents is the best choice, especially if for example someone is using rear mounted PSU like me, I would happily pay for one,even if it is expensive. Please make it happen Sliger, would be amazing.

Thank you, I'm very happy with it! : ) The noise levels are really good, the card is silent, I can't hear it over the AIO and case fans during hours of gaming.

Finally my build is done, I'm really happy with this PC, I got all the stuff I wanted into the case and temperatures are great. Thank you to the maker of the case, to @KSliger for superior support and patience, and @3lfk1ng for advice. Here is imgur album; Specs are; Cerberus X case, Ryzen...