Recent content by james1976

ok i guess i will use all 3 cause i got no idea just winging it and i can't find no info the only thing i know psu is meanwell se 600 24, it is 600 watt 24volt 25 amp

thanks

so i got some 6pin minifit jr connectors aka 6 pin pcie i was going run one from the hdplex and mount the end in the case panel basicly it is just like a 6 pin gpu extension from the hdplex to rear case panel. then a male 6 pin molex with the 6 wires coming out of it to the ac-dc power unit. so...

i'm just winging this so got a question. how the power into the hdplex is a 6 wire plug should i run each wire to seperate post on the psu or can wire 3live wires to one live post 3 neutral to one neutral post or use all 3 posts ?

ok thanks

so can the barrels just be disconnected and use the 4pin connectors to power the unit ?

can you link the psu you went with ? i have 2 330 watt dell bricks too is there any way to hook the 2 bricks to just the 400 watt hdplex cause i also have 2 240 watt too and a second hdplex 400

patiently waiting

you can remove the top grill by bending back some tabs then screwyour fans in. i havent done yet but with grommets removed reg fan screws should work

i wonder would a wire off the cases power button that goes to the mb and the power on pins on the 400 watt unit? what power source do you plan to use ? i am leaning towards the meanwell se-600-24 unit was going to go for 700 watt but here in canada the price is over 100$ in difference of what i...

how can i order one of these units to canada ?

did this ever happen ? i'm looking for a way to run hdplex 400watt and 200watt direct plug off one power source or combined power bricks if possible i am currently looking at meanwell se 600w 24v unit would that power both psu? and how could i wire the hdplex units to power on and off together...

thanks

do you have any 500 or 600 watt sets ?

what all would i need with a meanwell psu to power both a 400 and 200 watt hd plex ? i was looking at this unit here i don't really know if it is good or not i been looking for a week also on the hdplex 200 there are 2 pins 5v sync and on the 400 above 24 pin there are 4 jumper pins ps on...