Recent content by Insanniti

  1. I

    5800x, TUF 3080ti, Kraken X52

    I did do a build with the TUF 3090 in the NCASE (which should be same size), and while it's a very tight fit - I did manage to put the 2 x 15mm fans under it - although needed to stick some rubber spacers between the fans frame and GPU shroud to maintain the gap. If your GPU temps are decent...
  2. I

    5800x, TUF 3080ti, Kraken X52

    Depending if you're happy with the current temps, you may find the following fan config's better: * Change the 2 x 25mm (NF-A12x25) on X52 radiator to intake, rather than exhaust * Put the 2 x 15mm (NF-A12x15) as intake on the bottom under the GPU (may need rubber spacer inserted, as is tight...
  3. I

    Replacement plastic clips for panels

    Thanks ! Downloaded the STl file & will get them printed locally 😀
  4. I

    Replacement plastic clips for panels

    Is it possible to order replacement clips from anywhere for attaching the panels ?
  5. I

    NCASE M1 V6 GPU Compatibility List

    I have the non OC 3090, and the only difference seems to be factory overclock. You could use Afterburner to achieve this anyway on the non-OC - mine will run +200 on the core and +1000 mem for benchmarking at less than 67 deg max. So in the same way, if you want to reduce thermals or power, you...
  6. I

    NCASE M1 V6 GPU Compatibility List

    I have an Ncase M1 with the 2080Ti Strix, and while it takes some patience to get in, it definitely fits. I even have 2 x A12-15mm slim Noctua fans under it at the bottom - I did need to slide in a few rubber wedges/spacers to stop the fans hitting on the shroud though.
  7. I

    Advice Optimum Tech - Ncase M1 Dual Radiator Clone with available parts

    Yeah exactly from my experience too. Increases in pump speed are not as effective after a given flow rate, compared to increases in Fan speed - for removing the additional heat. Yeah the quadro supports the Delta T, you need to use virtual sensors in the playground of aquasuite. I can take...
  8. I

    Advice Optimum Tech - Ncase M1 Dual Radiator Clone with available parts

    If using Delta Temp by creating a virtual sensor from Water - Ambient Temp sensors, then you no longer need to base your fan/pump speeds from the load or component heat. Instead you set your curves from the Delta Temp of the Water, ie as the load increases, the water gets warmer, and then you...
  9. I

    Advice Optimum Tech - Ncase M1 Dual Radiator Clone with available parts

    Are you not using the Quadro to control the pump ? I have a dual rad NCase build, with a quadro & set it up to use delta T (ambient / water) to control the fans and pump, runs extremely cool with a 3950x and Radeon VII both in the loop