Recent content by imparanoid

If you want the back side to look neat this might seem silly but what about using a countersunk/bore on the backside to at least make a nut flush. Or a countersunk/bore bolt on the backside with a female-female standoff. Bolt head would be flush with the backside of the panel, and you can...

I disagree with IFreilicht. Rule of thumb I've been taught is 1.5 times major diameter of the thread (M3=3mm in this case). For this reason you'll find that Mcmaster, Fastenal, and Misumi has smallest threaded length available as 4.7mm. Go the way of EdZ and cut it down if needed, but...

Quite the contrary that is good to hear because I am in the middle of 3D printing a new shroud to accept a Cryorig 120mm slim!

Greetings all, I remember seeing a while ago some posts about the Gigabyte 1070 ITX card and there was some speculation that the shroud could be removed to avoid the hump. Mine came in last night so I figured I would take some pictures, remove the shroud, and give everyone some better...