Recent content by Gripen90

[ Ark ok. I can't quite remember it since I didn't pay much attention to it when I had it disassembled. I know the brand was RQET and it was 0.20A.

Just be aware that the card will get hot - very hot. I had one MSI 1030 passive cooled with the "dual slot" heatsink, it quickly went up to around 88°c which was a lot of heat just dumped into the case. I switched it out for a Gigabyte GT 1030 Low Profile single slot with a 40mm fan, and it goes...

So I got all my stuff last week to "mod" my G1504 too. I took apart the ASL G1504 and installed some Arctic thermal pads and replaced the thermal paste with some Gelid GC Extreme thermal paste instead. Initially I had installed the fan shroud, but I found out that cooling improved by 3°c when I...

Looks very nice ! I can tell you that after I installed a 2pin to 3pin adapter to my G1504 and hooked it onto an external fancontroller is it so much quieter. I also added some Arctic Cooling 1mm thermalpads to the Vram and replaced the thermal paste on the GPU with some Gelid GC Extreme, and...

Awesome ! Do show some pictures when it's all ready - and some temperature readings of course :)

Arh I see, yea open test bed does help temperature wise. In this tiny case and with limited airflow to the card I did a couple of hours Overwatch gaming at epic settings and it hovered around 82°c. I then to experiment took a USB 100mm fan as set it to the side of the air intake to the GPU fan...

How hot does your G1502 get with the noise adapter attached under load? I tried testing my G1504 with Unigine Superposition in High detail and the temperature maxed out at 81°c. In 3Dmark Fire Strike and normal gaming it would hit around 76°C.

Looking good ! Yea I wrote to the seller after following your original link yesterday, and I asked if he had any more of them. He replied and made the listing for pair more (sets of 2), and I went ahead and bought a set. I also bought a VGA 2pin to 3pin fan header adapter, because I was thinking...

I got my ASL GTX 1050Ti Battle Flag 4GB (G1504) yesterday. Everything works fine, however I also have the fan noise "issue". I would have purchased a resistor to mount also, but can't find any available ones, so for the time being I'll deal with the noise. I have the card mounted in an...