Recent content by FunkEngine

Just got around to dry fitting the case together and found this, any advice on bending this back into flat? I'm worried it might mess up the fit since the radiator area is so tight.

I checked the first post, thank you very much. The only mention of flipping the psu is that you can. I did some looking to find some of the pros and cons of doing so, like more room by the aio and harder to route tubes with version 1.0. I was not asking anything about flipping the case, only...

hi I'm ordering some custom cables from pSlate and I'm running to the dilemma of whether or not I want to flip the PSU. I'm going to be using the case in 3 slot mode and flipping the entire case for top exhaust and using an LT 240. I think the extra space by the radiator would be good but it...

Okay that really sucks. But I'm also pretty sure ballpark shipping and import taxes have been known since test shipping.

I mean it's only another $10. With case and shipping prices it seems kind of silly to draw the line there.

Is that just for the electronics or will you need a new front panel with cut outs?

Does the two tone still have the usb c port and card reader or was that scrapped entirely?

I have the lt240 installed with noctua backplate on my asrock x570 board. I have a post a while back about it in this thread. It's pretty easy to use. Just use all of the noctua hardware as instructed, except the cross members obviously. I don't know if it's the combo in general or a quirk of...

Yeah the included bracket is abominable. I've been using the secufirm hardware with it. I don't know if its a quirk of the lga 115x mounting on AM4 or if its inherent to the combination of the dclt and noctua stuff, but the posts are just barely long enough to engage the nuts. I also am unsure...

Daily 240 rad answer: you literally cant use any other 240 rad. Lt240 or 120mm.

No. General availability should be after the virus situation settles down in China. Sounds like it ships most anywhere.

On that note, I can try it full water cooled with my 1080ti and then just cpu plus 3 slot 2080ti for temps if that's useful information.

I'll take the general usa slot if still available. I've got the lt240 already and have nodded my board for it, mentioned earlier in the thread.

I've said earlier that I would have preferred preorders to be before the review. I've been quite consistent.

Not going to lie, I'm pretty unhappy about the review before preorders. There was already 10x demand before this, and now there are so many people that its crashing the site. It just feels like a spit in the face to everyone who has been following the project for months. The chances of actually...