Recent content by Fitchew

Hey @TaylorChiller I think you should add info about mDTX support with fans and rads scheme in the small picture features section.

@TaylorChiller As I understand it, the video shows a case that has not yet been finalized based on the comments from here. For example, in a video there is a motherboard frame with some kind of stiffener. This edge stiffener will obviously not allow you to install mini-dtx board.

This is really nice video.

This one for me is really important too.

I think this is the best option. I'm for middle variant.

My waiting intensifies

Hey @TaylorChiller is there any news?

This is fine for me! In fact, it's even better if you can give us a deadline ahead of time. At least I can plan my budget a little better. I am not upset by this delay at all. I believe that it's better to take all the factors into account in advance and get down to business than to face the...

Hey @TaylorChiller hope you doing well. I have a few questions. Is it possible to pass through tubes inside case under the top cover to bring them out and connect an external radiator? Or is there somewhere place in the back wall to make holes for such a connection, for example, to put adapters...

Still didn't get any. Check your conversations pls.

This is pretty clever idea. Lots of us would like to cerakote case

I'm ready! Lets go! Just say yes and take my money!

@petricor And what's the tool btw?

Hey, @Alloy Craft! I wrote a letter regarding participation in the beta test, but I never received a response. If it is not difficult for you, could you answer whether I got into the beta testers group or not. And by the way, the blocks looks amazing. I don't even know if they could have looked...

This is pretty clever! I like it. As I wrote earlier, I am ready to become a beta tester. I have the following components if it's matter: 1. R9 5900x + Asus x570 Impact + RX 6900 XT RedDevil w / c + original Nouvolo Aquanaut + Barrow SPB17 + 2 * 280mm radiator 2. R3 4350G + Asrock B550M-ITX/ac...