Recent content by fatmandandan

No Problem! Glad to help. From my fitting, the 90 degree Rotary 10x16 Should fit directly on Aquanaut. Standard 10x16 do not, The compression nut is slightly too large and will hit the DDC. You should also be fine height wise, I don't think the normal 90 10x16 is too much taller than the low...

Going off of the 4th picture and working my way from the top right corner to the bottom left, the fittings are: Koolance QD3 10mmx16mm, Koolance 10x16 Compression, Koolance 20mm Extension, EKWB 90, Koolance 4 way fitting body, Koolance QD3 BSPP 1/4, Koolance male to male swiveling coupler...

Here are some pictures showing motherboard clearance with the Strix X570-I. There's about 5mm between the heatsink and the water block

Yup!, Planning a full loop rebuild later today, so Ill try to grab some higher quality pics showing the clearances around the socket. Also about pump noise, I just ran it at 100% to normalize results. Normally I run it at around 1200rpm and both the aquanaut and the APD2 are functionally...

Nope, I haven't found it necessary. In normal use I run the pump at 15% pwm and even with the fans spinning at an inaudible speed, the pump casing never exceeds 30 C. If anything, i'll probably 3d print a casing with airflow holes to allow air to flow around the armature.

Just finished some quick tests and the results are looking good! Just keep in mind that they are in no way super scientific and should be treated as anecdotal: The Loop was stressed using Cinebench R20 Looping for 1 hr to reach steady-state conditions. System: CPU3950x (Locked at 4.0ghz...

Just got mine in! Planning to run some temp tests vs an apogee drive ii later this weekend