Recent content by DougmanXL

@BrucDan I was a bit worried about damaging the RAM slot on the motherboard... I've had SATA connectors detach from mobo's in the past. Fortunately the cables tend to stay bent and you can connect them to the front panel like in the picture below. Also, for those wondering, you can fit a 3mm...

Connect everything, (i had to put on a cable with 3 sata connectors just to power the fans). I shoved a lot of extra cables into the front panel area. Get the New CAM software version. Install the extra firmware update. Get the new chipset driver...

I know some people have been discussing ventilation etc... hot air does rise, but slowly, and forced air goes in the direction of the fans following the enclosed space. However any change in direction or obstacle in its way slows it down, so exhausting air out the bottom will result in somewhat...

What CPU were you using? The CAM software has issues with the Ryzen 3000 series. Edit: I heard that it was causing overheating and not accurately monitoring the CPU temp (on reddit). I was going to try and use another software, or set it up and disable it... I've found these so far, but I...

I also didn't get tracking yet, I didnt modify the order except that I wanted the IO sent later and to pay shipping... good to know that the NZXT x62 will fit fine, if so then I think my ram will fit ok, as its about the same height off the board. I'd like thank all the people at Sliger for all...

@wsgroves Oh, ok. The bios fan can shut off if the chipset is running cool now. I'm not sure if that takes the ssd into account. The same bios update also allows custom fan curves, I'll just allow it to run silently always then. @Bioforce I would try test fitting it by mounting it on a...

@wsgroves I was going to use both, a 1tb on the front and a 2tb on the back, so I wont need any 2.5" drives. So long, SATA cables! I was hoping to put a heatsink on both m.2 drives if possible, I could put a 3mm thick heatsink on both, but I also have a 10mm one I could use. I dont have my...

I have a gigabyte x570-i motherboard, and one m.2 slot is on the back side if the motherboard, its like that on some other mobo's as well afaik. Do you think I can put a small heatsink on that drive? It looks like it would be behind the riser cable. I have a heatsink thats 1cm tall and I...

Will I be able to buy the no IO case from Canada? I would be willing to pay extra for shipping in order to get it sooner. I need a case by mid July that supports 240mm AIO.

Is the 240mm fan bracket going to be in stock at the same time as the no IO case? I'm planning on building a portable workstation with a kracken x52 and a 3900x or 3950x, and I want to be able to overclock it. Also does anyone know if the height of the dual m.2 mounts on the asus rog x570-i...