Recent content by Dogzilla

Ah, ADDA, even less of a point then, I doubt it's gonna be much different than a good sample Yate Loon, just better QC, less chance of weird noise problems, If you aren't sending already, sending an ADDA to L91, Caselabs . org, for him to add the recording to his review would make more sense...

Unless, you maybe wanted to check out how the Deltas sound to my ears, at idle, lower speeds + power consumption, especially considering I seem to have gotten a really good Yate Loon sample ? Because I remember you mentioned on a discord server, that you were possibly looking to go with...

Thank you for the offer, but I'll have to kindly refuse, I don't wanna put you out. At the end of the day low noise quality, and lack of specific low and high-frequency noises that only show on frequency spectrum analysis, and get missed by usual raw dBA noise testing are my top priority. What...

Also, to be fair this doesn't really apply to most people, most people would 1. run an air conditioner, not get room temp to 34-36C 2. have nice expensive well-ventilated cases, not cheap Sama IM01 clones 3. use case fans (or have direct airflow to components in <7L) 4. don't have the PSU...

Swapped back to the stock Yate Loon fan, ran tests again, Dragon's Dogma 2 demo, Furmark 2 + Cinebench loop, rock stable, except the Yate Loon fan goes to like 6000-7000 RPM or similar. It's def fine, it works fine, room temp is not exceeding 40C ambient, but the temp inside the case at PSU...

I might give it a shot, though I'm worried about the resonant noise, once flipped, due to the PSU grill, and I don't wanna cut the grill or anything just in case I do end up reselling the unit xD

Sama IM01 clone, no additional case fans, one side of the case opened, PSU exhaust into a fine mesh side. The FSP CST350 Plus clone, SAMA IM01 panel holes aren't good, they obstruct airflow too much :(

👌 I'll keep it in mind when I get into a more proper case, so far it works, but yeah, I'll try to zip-tie it another way or even, drop them, later on. On another note, the Noctua NF-A4x20 fan isn't strong enough to cool ~200W in summer (~36C degrees room temp), for the speed/noise I was hoping...

First Impressions on Overtek uk + Enhance ENP-8345L-OVT 450W FlexATX, very good, no coil whine, stock DBB Yate Loon fan surprisingly quiet for being a ball bearing (nicer sound that Scythe Gentle Typhoon 120mm Noctua A12x25 at about ~1350 RPM masked the noise from the 40x20mm DBB Yate Loon for...