Recent content by Dezz

I've been looking for someone to try a build like this. I'd be very interested to see a build log or pictures when you're done, plus any feedback on it!

Ah yeah I see now. The new 330 watt brick I just got is a GT1CX/LA330PM160 by Lite-On Technologies. The sticker is formatted differently as well. I can take a picture of it if someone wants. So far it's running great. Pushed my 7700k to a slight overclock and played Overwatch for a couple of...

I thought the manufacturer was Delta Electronics?

I did not try the fan thing. I'm confident it isn't an issue with heating as I could trip my system upon immediately hopping into a game of Overwatch when my PC has only been on for a few minutes. I've run this same brick for many hours at a time with heavy load on a 7700k/1060. I did get a new...

You're right about that, but the brick itself doesn't indicate that

@Josh | NFC @royalba94 @Biowarejak I purchased my brick from "IT Wholesalers" on Newegg. It looks 100% legitimate but it could be fake. Model DA330PM111. I've turned off Turbo on my 7700k and have only had it cut off once in about 5-6 hours of gaming. Obviously I want to be able to have turbo...

Yeah it should be, but whenever I hop into games power gets cut. Cant really tell if its the HDPlex 400 or the Dell 330 watt.

Any advice on HDPlex 400 + Dell 330 watt unable to provide enough power to my system? I've got 7700k+1080, essentially the same build from this video: Edit: also the Zotac 1080's fan likes to clip the case/3d bezel I have. Its like its just a mm or two too long for my bezel.

Does anybody know of any build logs or pictures of somebody using a Zotac 1080 mini and one of Gury's power solutions in their S4 Mini Classic?

My Noctua NF-A12x15 seems to be just slightly too big to sit behind my graphics card. I could fit it in there if I wanted to but it would push the graphics card and also bulge the side of the case a bit. Has anyone run into this issue as well?

Can't answer all your questions, but I know that the Zotac 1080 won't fit without the 3D bezel replacement. It's too long to fit into the case with the wrap around unless you shave off the end of the fan shroud.

Does the R3 S4 Mini still have the power connector port pre-drilled for the Pico PSU adapter or has it been updated to fit the HDPlex adapter?

Does anyone know a lot about surge protectors and could recommend me a good travel sized one that would be appropriate for my S4 build + a monitor? Say max power draw is probably around 500 watts, and total equipment cost (that will be plugged into surge protector) is about $2000.

So August is here, September is coming up soon. Any chance we'll see the September pre-orders shipping out early, maybe late August?

Going to be using a 400w HDPLEX in my S4 Mini with a build very similar to the one Josh used in his 1080 in an S4 mini build. Who can I pay to get custom sleeved power cables for my build? Ideally someone who is familiar with that layout and can cut proper lengths and keep the final cable thin...