Recent content by Cyruz

Me2 xD Hm very strange You have the aio on the aio port of the board? Maybe test another fan header

Maybe test a Molex fan adapter with the Pump ( or test without Mainboard), very strange thats the sound is changing From the pump. Maybe you can check with hwinfo the Powerdraw from the Gpu. You say it´s not in windowed mode. So i can imagine in windowed maybe powerdraw lower from the Gpu...

Maybe shake your case a little bit or turn it to all sites, mostly when aios makes noise then air bubbles is the reason. Next week my 645 comes in my a4, on the testbench it was ok with 7v adapter and without. Maybe the sound comes from a pwm controller from your board, have you set manual dc...

Maybe can daniel say whats the right directon of the riser cable. In the manual is mainboard site

You will need a 3pin DC for the pump and a 4pin pwm for the noctua fan.

Thx for reply. I tested yesterday with and without low noise adapter from noctua works so far. Temperatures are fine so far, but intense testing is in the future when my a4 comes to me. I ask because my mb reportet 5400rpm or 5200 , when i‘m throttle to 7v it reports 2200-2500 i think thats ok...

I already ordered per ocuk and now wait until on stock, but one question Is it possible to moint the pump with a low noise adapter to reduce pump speed ( noise) ? Or should i leave it all times on max power? Reduced lifespan and so on?

The Temperature Is with stock fan or 120 and vlp @ gucksTV?

Ok then i will go with l9i and a fan duct as 3d print from your website. Thx for response :)

Hi, i ordered my v4 from sfflab. Can‘t wait anymore, so i began with mounting from the rest. Now i stand before question Blackridge or L9i with shroud. I can only use a 92fan ( corsair lpx ) Which is better to cool a 9900k ( delidded and i know that i must throttle the CPU a bit , but the cpu...