Recent content by Caedis

Hmm... maybe I spoke a little too soon. Optimum Tech compared the two cases more directly in his H1 review:

This case will perform significantly better than the NZXT H1. I don't have hard numbers though.

Nice! Anything I should know about the method that might not be obvious? Do you use the quick disconnects when draining the loop or do you add separate fittings? Any insight or advice would be very appreciated! Thank you!

Does anyone know if the PSU bracket will be adjusted to better accommodate EVGA power supplies? I know there was a a problem where the lip of the switch would interfere with the bracket, but I don’t see anything listed under the T1V1.1 changes.

Has anyone tried the "quick disconnect method" to fill their small form factor loop? Optimum Tech mentioned it in one of his videos that he was waiting for specific quick disconnects to try it out but then ended up not doing it. I assume it works by having two sets of disconnects, one in your...

Does anyone have detailed measurements for the top and bottom vented panels? Or know if @Wahaha360 Provided CAD files at some point? I am looking to machine a wood panel to fit on top of my (future) T1V1.1 similar to these“ghost sheets.”

Has there been much consensus on what is the best tubing to replace the stock alphacool eisbaer lt240 tubing? I'm going with EPDM for sure, but what diameter provides the best cooling, but can also comfortably fit inside the T1 and isn't too restrictive for the stock pump? Thanks! Alphacool has...

I was wondering the same thing. Why is there a single hole at the back of the case?