Recent content by blackreplica

I supported Dan since the first gen A4-SFX (he even used a picture of my build on his website to market the case which was cool as hell for me). I was only able to get the C4-SFX because my brother lives in berlin (and he is still using my Intel 7700k/EVGA FTW3 1080Ti first gen A4-SFX build to...

Thank you:) Regarding the tubing run for the side rad, yes it does put a little pressure on the tube + fitting but with good fittings (bitspower) and tubes (EKWB ZMT) i am confident it will hold up, right now when the side rad is attached, the tube coils nicely on top of the motherboard and i...

Well this certainly qualifies as my most ambitious build to date. Not sure if Dan intended this, but this is probably the smallest form factor case that can fit the surface area of 4 x 120mm rads while being able to fit a D5 pump. Why a D5 pump? The pump/res a carryover part from my previous...

Hmm I personally prefer the V1 more rounded, organic design (although i guess such a panel shape makes it much harder to flat pack). Am glad i was lucky enough to be able to get my hands on a V1 but I don't think the V2 is any better or worse looking than the V1. There are some interesting...

If you are referring to this post, he is running 30mm rad + 25mm fan (there is no 15mm 140mm noctua fan) + waterblocked single slot GPU and to my eyes there is plenty of breathing space. I am planning on doing the same with another single slot GPU + 280 EKWB rad + 25mm noctua fan

May i confirm you are using 25mm fans with a 30mm rad? What is the thickness of your waterblock? am trying a similar dual rad build and want to make sure there is adequate room with the parts selection. Trying to get by without using ultrasl fans and with 30mm rads if possible

Sorry if this was asked before Is it possible to install 2 2.5 inch drives on the front using the stacking bars? Will there be enough space to mount the case's front face on?

Hi everyone, am I first to receive the silver Ncase M1 V6? Pics of the face plate is attached. On the faceplate with the ports, I can't see any injection marks at all. On the blank faceplate, seen super up close from the bottom, there is a small mark. I do not in any way consider these as...