Recent content by bhk1004

oo interesting. wonder if itll work on the strix 570 board. I got the one below previously and it gets in the way of other cables and wont fit. currently just running it disconnected.

why do you think it wont fit with the loser card mod? just curious what measurements you are looking at cause when I checked it should fit fine. wondering if I looked at the wrong measurements.

I dont see why not. Just remember you need something to block the psu cables from touching the fan blades.

Is the plastic to be removed for all builds? Or what is the driving factor that you should remove it?

Will it even matter if there is no air circulating? Atm he needs to fix his air issue. He doesnt need to really touch his cooler cause in the end no matter the cooler hes going to have the same issue if the air is just boiling inside the case. Whether its opening the side or flipping the fan...

If glass off works to keep temps in check, just get some spacers, and gap the glass to get some airflow. Wont be the best but will definitely help. Definitely an air flow issue if you are hitting over 90 with l9 on a 3600. Good luck!

Those temps with a 3600 I'd think you incorrectly seated your cooler. I'd remove the cooler and redo the thermal paste. Test the side panel off and also try switching the fan from push to pull or Visa versa. Also the cpu fan. Also noticed the case is almost sealed up. Taking off the side see...

It looks like a system gpu. Not for individual purchase. https://sp.ts.fujitsu.com/dmsp/Publications/public/ds-graphics-pc.pdf&ved=2ahUKEwjRjp6iv9noAhUJhuAKHR8UCekQFjAAegQIAxAB&usg=AOvVaw2nJeNcbbe-ZgrBdYPyw-Zs

Seems they weren't sold separately? Says only approved for fujitsu systems. Would explain why there is no box...

I'd say give it a try. Worst case you just run eco mode if needed. I run between eco and stock for my 3950x on 645lt mainly to keep it around low 70 degrees max off prime95 which is plenty for me. I think all core boost is about 3.6 for eco, I'm running around 3.8 and stock is around 4 ish. I...

This is amazing... and making me want to buy a 3d printer. I have been contemplating for years at this point. keep up the good work buddy!

yep got a cable. but its a bit strange to place properly, and a bit nervous about the adapter just exposed and flopping around. so i haven't installed it for now. i also have 0 usb-c to usb-c device/cables. will install it when this actually becomes the norm, and wrap the adapter in electrical...

prime95 for for about 15-20 minutes. just depends what you want. i wouldnt want to trade in a 240 aio for a 92 unless i had to. Ghost didnt fit my space constraints i had.

60 during bench for eco + pbo. 80 during bench for stock settings. Currently just using stock. Will probably end up somewhere between the 2. Will play with it this weekend.

Depends what temps you are ok with? I have a 3950x with asetek cooler and losercard mod. Eco+pbo I dont over 60 degrees no matter what I do. Stock, running bench for 20 minutes I hit 80 degrees max. I guess use these numbers to help decide? O and I'm running prime95 for bench. Good luck!