Recent content by aporias

Thanks, so exhaust seems to be the slightly better option as it seems!

Thanks for your findings. So the fan under the PSU is better as exhaust than intake? Did you use the original feet? I think a small tweak would be adding slightly higher feet 2-3mm than the original ones. But seeing your temps i'd probably be happy with it also, depending on the gpu fan speed...

Hi there, as far as i know there are no confirmed specs about the T1 EVO. Do you mean the current T1 V1.1 or upcoming V1.2 update? The latter is designed for a 120mm radiator officially but you can fit a <25mm thick 240mm radiator in there without any problem by using 14mm fans. The new...

Might as well go with an open case or another case altogether. What is the point of going outside of the limits of the case? I don't think this is very helpful for anyone looking to make the RTX 30xx Founders Editition work in the DAN A4.

And to get into the topic again: one of the really strong points from my point of view would be to be build upon the modular possibilites of the original T1 by adding even more possible locations of the gpu mount, psu mount, top strut and so forth. This is what makes this case unique in all the...

The best solution is probably going with the EK Classic w/ the vertical Terminal in this use case. It should fit with 1,75". However i am unsure if it would be possible to a mount the gpu with a 2 slot bracket while the top strut / spine offset to 1,75". Well anyway - if one day the updated...

Thanks! I just researched the GPU fittings issue and you are probably right about the EK GPU Block with EK-FC terminal. It seems there is no perfect solution :) I think there may be a similar option from Barrow but i don't wanna go off topic here. Are you using the Koolance Low Profile...

Hello sfforum, i am currently planing a wartercooled build for a T1 1.2 in the near future. I know there are countless options for a custom loop in this case but i have a specific questions about the Barrow LTPRP-04 Waterblock / Pump combo which currently will not fit in the 1.1. I think we are...

I have also looked how to get a similar setup running. If you have not done it already you can offset the graphic card to the outside with additional 5mm motherboard spacers on the pci-e riser, in order to create a wider gap between the backside of the gpu and the psu. I would then look into...