Recent content by acer

That's awesome I didn't know about silver cables being slimmer and more flexible, thanks for the tip I'll probably swap it out! I bought a generic mustard and ketchup extender 24 pin cable that wasn't wrapped and its surprisingly flexible and should do the job for now! Thanks for the help!

This is the board I'm using, if you could imagine the IO facing to the right in that photo that's what I'm working with. I've bought a extension cable for now and I'll try just compress it down as much as possible and run it at the small gap at the bottom of the RAM slots.

I need to find a 24 pin right angle connector but need it the opposite way to the conventional 24 pin right angles you find. I've tried looking but unsure where or what to search in order to find what I'm looking for and thought someone on here might be able to help me out. I need one of...

Thanks!

Thanks I tried ordering this but they don't ship to the UK which sucked.

Anyone know a way of ordering this to the UK? I've tried from Taobao but it says "the product cannot be shipped to your country or region". Is it available anywhere else?

Here's an image for reference.

I've purchased a right angle kettle lead which I could make fit but it would be kind of hacky, does anyone know if a low profile right angle kettle lead exists and where I could find one as short as possible? I've tried all over but they all seem to be around the same size + or - a few mm so...

I'm no expert but I've seen others use this PSU with what I imagine more power hungry equipment than mine, so would a Silverstone FX350-G 350w PSU be able to handle a rx580 under volted slightly and a i7 3770k?

Thanks for the reply! I can make more room between them I just wanted to know worse case from someone with experience. I know its kind of a stupid question as the obvious answer would be "as far as possible", but what would you recommend as a good clearance for a back to back system?

Hi, I'm currently building a custom build and just want some advice or questions clearing up about back to back gpu & cpu. How much space do you need between the back of the GPU and the back of the motherboard them? Could they touch? Or be within 1mm or less? I was thinking of creating a...

Thanks I will have to measure up and take a look!

Hi I'm currently building a project itx PC, I'm wanting a goods CPU cooler with decent temps and reduced fan noise although I would accept a bit more noise if the performance a good chunk better? Currently thinking of going with a Noctua NH-L9i, I have around 400mm-500mm head room to play with...