Recent content by 3geekfamily

Correct.

Absolutely insane how enormous that card is! If that thread on Reddit did something for me, though, it told me to look at my M.2 temps. As he saw, the M.2 drive installed above my 3090 is definitely warm - probably around 7*C warmer than it was with my 2080 Super. Looks like I might need to...

The EVGA 3080/3090 XC3 would be an even better choice. Only 2.2 slots wide, not very tall, and not very long, either. It would give you TONS of room to run 2 120x15mm fans, with plenty of space between the fans and card, to prevent excess added noise. Of course, it all comes down to which one...

Yes, I believe the 15mm fans would have plenty of clearance with the TUF cards, but still might be close enough to cause some wind buffeting. Might be worth it though, as the 120x15mm fans blowing on the card will probably keep the fans on the card from spinning up so quickly. For relatively...

According to the specs, the MSI Ventus RTX 3080 is about 1.5mm wider than the EVGA FTW3 3090, at 57mm vs 55.55mm (from Reddit, linked below) - so I would say no. You MIGHT be able to wedge them in there, but they'll be so close to the video card, you'll be adding a ton of noise, without doing...

No problem, glad I could help! Finally have internet back today. The middle PCIe power outlet was no problem at all. I didn't have one connected, because I had only ordered two low-profile adapters. I'm happy to report, my third one came yesterday, and everything now fits together perfectly...

It just goes to further prove how perfect of a case this is!

Oof, I don’t think I could do that, unless it was intentional!

Trust me, it was the one huge high point in an otherwise abysmal day for me. Haha Sorry, no link at the moment, everything takes a month to load. They’re on Amazon though, and prime as well!

With any luck, these two pics should be a good teaser. Tough to test on sub-1Mb internet! https://ibb.co/S6kdBK0 https://ibb.co/6mSygZk

Signed up just to say, EVGA 3090 FTW3 absolutely DOES FIT in a v6.1. Had to remove the front panel controls to work it into place. Left the plastic on the top-right corner, as it would have been marred otherwise. Fits, and the side even secures in place, no noticeable bulge. Used low profile...