Hey Guys,
With limited electronic expertise, I'm just looking to get some affirmation on what I am planning. I've bought the Z4 ATX 200 power supply and would like to use it with the HDPlex 160W AC/DC since the cable bulk associated with the HDPlex 160 DC-DC is pretty ungainly. Is it safe to cut the four wires going into the barrel connector and put them into a 4 pin connector to interface with the HDPlex? I was just going to dissect the barrel so I can see exactly which wires are +/- and then proceed from there. Also (stupid question) but + is yellow and - is black, correct?
With limited electronic expertise, I'm just looking to get some affirmation on what I am planning. I've bought the Z4 ATX 200 power supply and would like to use it with the HDPlex 160W AC/DC since the cable bulk associated with the HDPlex 160 DC-DC is pretty ungainly. Is it safe to cut the four wires going into the barrel connector and put them into a 4 pin connector to interface with the HDPlex? I was just going to dissect the barrel so I can see exactly which wires are +/- and then proceed from there. Also (stupid question) but + is yellow and - is black, correct?