X300-M(AX) case F3D file

Enclosure X300-M(AX) case F3D file 1.0

No permission to download

Curiosity

Too busy figuring out if I can to think if I shoul
Original poster
Platinum Supporter
Bronze Supporter
M...M...M...M...Multi-Tier...Subscriber...
Apr 30, 2016
724
838
Curiosity submitted a new resource:

X300-M(AX) case F3D file - Full design file for my x300M based case, supports a 140mm rad and a full length 2 slot GPU w/in 6L

F3D file for the X300MAX case, 5.7ish Liters depending on the side panel used.

Cutout for an XT60 connector at the rear for power out, uses a 3W3 Dsub connector for power in, ideally pins on the case side.
Specifically designed for use with the Corsair XR5 radiator, and even then will require a relief cut in the motherboard side overlapping the Rad for clearance, or direct mounting it to the spine.
Motherboard standoffs should be 6mm tall and mount to the GPU side's rear, passing thru the...

Read more about this resource...
 
  • Like
Reactions: msystems

Curiosity

Too busy figuring out if I can to think if I shoul
Original poster
Platinum Supporter
Bronze Supporter
M...M...M...M...Multi-Tier...Subscriber...
Apr 30, 2016
724
838
Necroing a thread 😶
Any chance of a reupload?
Absolutely, my apologies for it going down.
I'll update the link in the main post as well, but here it is in my reply.
Enjoy, and let me know if you need any help.

I can also be found on the sffn discord under the same username. :)