Normal
So I guess this is a super simple case internally, about 185x185mm footprint with two SSDs below the mainboard, right? The P5 seems very similar to the Lone Industries L2/L3 in terms of layout. Either way, nothing wrong with that, having 3D-prints and acrylic seems to be a good way to get cost down for a low number of cases.Could you try to rephrase that? Does that simply mean that the case isn't assembled by you or does it mean that you will sell the 3D printed parts over the shapeways store and publish the panels drawings for everyone to source on their own from local shops?
So I guess this is a super simple case internally, about 185x185mm footprint with two SSDs below the mainboard, right? The P5 seems very similar to the Lone Industries L2/L3 in terms of layout. Either way, nothing wrong with that, having 3D-prints and acrylic seems to be a good way to get cost down for a low number of cases.
Could you try to rephrase that? Does that simply mean that the case isn't assembled by you or does it mean that you will sell the 3D printed parts over the shapeways store and publish the panels drawings for everyone to source on their own from local shops?
