Normal
EKWB terminals are not easy to make yourself. The connection to the block is a rounded rectangle cut by a 2.5 or 3mm routing bit, and sealed with an unusual oblong and thin o-ring. (See e.g. second picture here https://shop.ekwb.com/ek-fc-terminal-dual-serial).But looking at Blk's photo, how many millimetres between the 2 terminals? Koolance for example makes a 3.5mm male-to-male G1/4" coupling. I'm sure there are other sizes available from other vendors. Then you don't need to cut, drill or tap anything. Just screw 2 terminals to each other in parallel, and attach to the blocks after they are inserted in the M/B.
EKWB terminals are not easy to make yourself. The connection to the block is a rounded rectangle cut by a 2.5 or 3mm routing bit, and sealed with an unusual oblong and thin o-ring. (See e.g. second picture here https://shop.ekwb.com/ek-fc-terminal-dual-serial).
But looking at Blk's photo, how many millimetres between the 2 terminals? Koolance for example makes a 3.5mm male-to-male G1/4" coupling. I'm sure there are other sizes available from other vendors. Then you don't need to cut, drill or tap anything. Just screw 2 terminals to each other in parallel, and attach to the blocks after they are inserted in the M/B.
