PSU / Asetek AI airflow issue in DanCase A4

[joflashstudios]

Looking for some advice on my DanCase build.

When installing the GPU, there's very little clearance between the bottom of the GPU and the top of the AIO fan. As a result, I have to spread out the PSU cables as much as possible or it prevents the AIO fan from spinning. However, this introduces a new problem where the fan is essentially 100% blocked by the PSU cables, severely limiting airflow.

How have others resolved this issue?

 

[rfarmer]

This is always a problem with the Dan and the Asetek AIO, best solution I have seen is a set of @pslate unsleeved 24 pin cable made especially for the Dan A4 SFX.

 

[joflashstudios]

This is always a problem with the Dan and the Asetek AIO, best solution I have seen is a set of @pslate unsleeved 24 pin cable made especially for the Dan A4 SFX.

Thanks for the tip!

 

[SoulTribunal]

A fan guard would also help but things are already looking tight in there eh.

 

[lilclie]

Maybe he could order or 3D print the PSU mod from @LoserCard to help with the clearance

 

[LoserCard]

Thanks for the mention.

To the OP, here is the bracket I sell (note, this is an old picture/version of the bracket):


They move the PSU up about 6MM upwards which helps a ton especially if you are using stock cables.

I sell these for $20 shipped to the US and around $30 shipped internationally.

Also the STL files are posted if you own/know someone with a 3D printer. Here is my selling post on Reddit: