Reply to thread

Message

Ooh nice, thanks!

Kinda stumbled into another problem I should have seen before asking actually ._. If I were to go into the laser route, then there's going to be 6 small studs I'd have to make elsewhere and use two layers of different thickness for the main body.

then I realised the boards they have are of pre-determined thickness. And then designing for 1.0/3.0 and 1.5/2.5 layers in the same project...
And that's not accounting for tolerances yet. site says actual thickness may not have the same consistency between boards. I'd wish to take on this challenge of multiple layers and multiple thickness aggregating to the same total thickness, but I'll have to skip for now

[MEDIA=imgur]a/ubLtI[/MEDIA]

So yeah. Unless there's something else methodologically I'm going to have to stick to being able to print the stubbles and the crevices together in their respective heights. I'm a bad person this way ,_,

Oh yeah I forgot about that. Is the ++ labelling still a thing from DP 1.3 onwards? o_o

<blockquote data-quote="VegetableStu" data-source="post: 59753" data-attributes="member: 666">Ooh nice, thanks!Kinda stumbled into another problem I should have seen before asking actually ._. If I were to go into the laser route, then there's going to be 6 small studs I'd have to make elsewhere and use two layers of different thickness for the main body.then I realised the boards they have are of pre-determined thickness. And then designing for 1.0/3.0 and 1.5/2.5 layers in the same project...And that's not accounting for tolerances yet. site says actual thickness may not have the same consistency between boards. I'd wish to take on this challenge of multiple layers and multiple thickness aggregating to the same total thickness, but I'll have to skip for now[MEDIA=imgur]a/ubLtI[/MEDIA]So yeah. Unless there's something else methodologically I'm going to have to stick to being able to print the stubbles and the crevices together in their respective heights. I'm a bad person this way ,_,Oh yeah I forgot about that. Is the ++ labelling still a thing from DP 1.3 onwards? o_o</blockquote>

[QUOTE="VegetableStu, post: 59753, member: 666"] Ooh nice, thanks! Kinda stumbled into another problem I should have seen before asking actually ._. If I were to go into the laser route, then there's going to be 6 small studs I'd have to make elsewhere and use two layers of different thickness for the main body. then I realised the boards they have are of pre-determined thickness. And then designing for 1.0/3.0 and 1.5/2.5 layers in the same project... And that's not accounting for tolerances yet. site says actual thickness may not have the same consistency between boards. I'd wish to take on this challenge of multiple layers and multiple thickness aggregating to the same total thickness, but I'll have to skip for now [MEDIA=imgur]a/ubLtI[/MEDIA] So yeah. Unless there's something else methodologically I'm going to have to stick to being able to print the stubbles and the crevices together in their respective heights. I'm a bad person this way ,_, Oh yeah I forgot about that. Is the ++ labelling still a thing from DP 1.3 onwards? o_o [/QUOTE]

Verification