Normal
A little more tweaking, hdd and psu need to move slightly to the right. then the psu can slip under the metal frame on the left side. hdd height is good, psu moves 1cm downwards, to fit the height of the power plug.the 150mm top fan was great, but I switched to the slim and smaller 120mm noctua. I don't want to cut the side panel atm. I did cut larger holes into the bottom of the case though, to allow for more airflow.the gpu power adapters are quite sketchy, but without fans and light, it should draw a little less power =) Is there anything more robust out there on the market?it's been a fun journey! I tried multiple ways to measure it. measuring tape and slide gauge...failed.what ended up working was tracing the holes of the front panel onto plot paper. had no scanner so did a lens correction for my mobile, then a homography distort to match my cinema scaling.
A little more tweaking, hdd and psu need to move slightly to the right. then the psu can slip under the metal frame on the left side. hdd height is good, psu moves 1cm downwards, to fit the height of the power plug.
the 150mm top fan was great, but I switched to the slim and smaller 120mm noctua. I don't want to cut the side panel atm. I did cut larger holes into the bottom of the case though, to allow for more airflow.
the gpu power adapters are quite sketchy, but without fans and light, it should draw a little less power =) Is there anything more robust out there on the market?
it's been a fun journey! I tried multiple ways to measure it. measuring tape and slide gauge...failed.
what ended up working was tracing the holes of the front panel onto plot paper. had no scanner so did a lens correction for my mobile, then a homography distort to match my cinema scaling.
