Normal
1. Thanks, that makes sense to me, but having the extra confirmation helps.2. Yeah, I wondered if I’d have to do a custom curve. I’m ok with that - I’m already under-volting in preparation and the same software offers customized curves.3. The board has two fans and two fan headers - I assume I could just grab two of the cables and run one to each fan? I guess if I used a splitter then I might not need to use a custom curve. I’m not sure if just adding the amps for the two case fans is the appropriate calculation there. My electrical knowledge is mostly based on things I‘ve done before - and this is not something I’ve done before.
1. Thanks, that makes sense to me, but having the extra confirmation helps.
2. Yeah, I wondered if I’d have to do a custom curve. I’m ok with that - I’m already under-volting in preparation and the same software offers customized curves.
3. The board has two fans and two fan headers - I assume I could just grab two of the cables and run one to each fan? I guess if I used a splitter then I might not need to use a custom curve. I’m not sure if just adding the amps for the two case fans is the appropriate calculation there. My electrical knowledge is mostly based on things I‘ve done before - and this is not something I’ve done before.
