Log My custom wooden ITX case

[Knives]

Hi, I just want to share my custom ITX case, made from MDF and with a top wood panel. Inside there's an Asrock Fatal1ty AB350 Gaming-ITX/ac paired with a Ryzen 5 4600G, 16GB of DDR4 3000 Memory, a Sabrent 512GB NVME SSD (for Windows 11), a 2TB HDD 3.5"for storage, a 2.5" SSD for MacOS Ventura and another 2.5" drive for MacOS storage.
The power Supply is a SFX 350W from BeQuiet (modded with a Noctua fan), the graphic card it's a mining RX 580 4GB.
The whole system (GPU included) it's cooled by 2 Noctua 120mm fans on the bottom.

 

[steelfractal]

looks nice how are temps in it

 

[Pagusas]

The front and top look very nice, what happen to the side though?

 

[Knives]

My paint job skills are weak at the moment, I'm planning to repaint better..

 

[Knives]

The temps are really good, 45 to 48 degrees max under full load (cpu around 55 degrees)

 

[Knives]

Little update: new paint job (muche better now) and added some back opening, now the airflow is a little bit better. Soon I'll post some images of internal + external.

 

[kiuas]

Hey, thanks for sharing!

It would be nice to hear more about your build, and see inside also, if possible! I'm wondering, for e.g. how did you fix everything, what kind of mesh pattern did you use? I don't see a GPU from outside, but you mention a GPU? Do you have a dedicated card, or is it only the APU?

 

[Knives]

Hello, there's the promised update, sorry for the delay:

• I changed the GPU from the RX580 to a RX5600XT from Sapphire. I removed the GPU fans and shroud, so I can cool it with the 12mm fans underneat, one of wich is controlled from the card itself.
• I replaced the PSU with a Cooler Master Modular 650W SFX, held in place with 2 metal corners.
• I also replaced the 3.5" Hard Drive to a 4TB Dual plate disk, wich is "hanging" from the top with some elastic bands to prevent any unwanted reisonance.
• I moved the 9mm fan from the side opening to the new opening on the back, now temps are 2-3 degrees cooler.
• I added a COB RGB strip (from aliexpress) wich I can control directly from the MB RGB port.
• I moved the PSU cable from the inside with a Male-Female cable, so it's cleaner.

It's really, really quiet, I'm very happy.

About the case build itself, the panels are 6mm thick MDF, I added some wooden segments (4-6-8mm square sections) and it's glued with PVA glue (some hot glue for not structural parts).
The rounded corners are made with an hand planer, than smoothed with sandpaper.
For the side mesh, I stole it from an old case (P4 era), glued to the side panel and bent the corners to act like a door edge to held the top part closed. Inside the bottom feet are 2 screw that hold the bottom part.
For the back exaust, I found 2 cheap air vents in an hardware store.
Now I'm searching a mesh for the GPU cover, to clean up all the back side.
I will keep this post updated, thanks and best regards.

 

[Roskow]

Cool build!
What is the volume of the pc?