Normal
A small 3d printed tabs, that wraps around the top and behind the GPU board, would also help with polarization. However, you'd be pretty airhead if you wired it, and then plugged it in upside down and allow the wire to hit the GPU and not notice it.Something like this (super simplified obviously)I would also entertain the idea of a 3d printed 6pin plug. SLS is not even close to the accuracy and smoothness of the plastics they use in molex connectors. However, since it is female, it just needs to be able to house the pin and fit inside the connector.
A small 3d printed tabs, that wraps around the top and behind the GPU board, would also help with polarization. However, you'd be pretty airhead if you wired it, and then plugged it in upside down and allow the wire to hit the GPU and not notice it.
Something like this (super simplified obviously)
I would also entertain the idea of a 3d printed 6pin plug. SLS is not even close to the accuracy and smoothness of the plastics they use in molex connectors. However, since it is female, it just needs to be able to house the pin and fit inside the connector.
